The Basic Transdimensional's Lifter Experiment
By Jean-Louis Naudin
created on October 10th, 2001 - JLN Labs - Last update October 16th, 2001
All informations in this page are published free and are intended for private/educational purposes and not for commercial applications

You will find below all the details and diagrams for building and test yourself the Transdimensional's Lifter experiment.

The Basic Lifter is a very light weight device, only one upper frame is built and the aluminum sheet must be very thin. This is a very fun experiment which worth to be replicated.

The Basic Lifter is maintained on the ground base with 3 thin nylon threads to avoid that it escapes to the ceiling...
The Basic Lifter remains very stable above the ground while the power supply is energized. A 330 Kohms/10 Watts resistor is connected in serie with the HV Output to limit the current flow.

This High Voltage power supply used is able to generate up to 25-30kV DC Output from a 12-24v DC input. With a fully adjustable DC input power supply (0-24V/4A), it is possible to adjust the HV output between 5 to 30kV. This HV power supply use a common flyback driver circuit with two 2N3055 power transistors as a push-pull oscillator. A common flyback transformer from an old TV/monitor can be used, the transformer HV output is connected to a 30kv Voltage tripler which commonly used in all color TV monitors.

In the Basic Lifter experiment the DC Input of the HV Power supply is 15 V @ 2.3 A.

A close view of the HV tripler

BE CAREFUL, USE EXTREME CAUTION !!!, this device use High Voltage, ALWAYS switch off the input and discharge the output to the ground through 10k/2W resistor before touch it. These plans are not intended for the inexperienced. User of this document should be very carefull and experienced in High-Voltage electronics to try anything out ! If you do it the risk of any results is just yours. I take no responsibility of anything that might happen.

See the video demonstration of Basic Lifter

To see the videos, the free downloadable RealPlayer is required

Click on the picture above to see the video ( 701 Kb )

The Lifter1 works also very well with this 30KV power supply

How to Build yourself the Lifter1

The Lifter Thrust Calculations by Steve Burns ( 10-18-2001 )

Email :

Return to the Lifters Experiments page

Encyclopedia of free energy now on CD click for more information